Dell MX5108n OS10 Enterprise Edition User Guide for PowerEdge MX IO Modules Re - Page 471

Parameters Default Command Mode Usage Information Example session-ID - Enter the user session ID. Not configured EXEC None OS10# kill-session 3 Supported Releases 10.3.1E or later show sessions Displays the active management sessions. Syntax Parameters Default Command Mode Usage Information Example show sessions None Not configured EXEC Use this command to view information about the active user management sessions. OS10# show sessions Current session's operation mode: Non-transaction Session-ID User In-rpcs In-bad-rpcs Out-rpc-err Out-notify Login-time Lock 3 snmp_user 114 0 0 0 2017-07-10T23:58:39Z 4 snmp_user 57 0 0 0 2017-07-10T23:58:40Z 6 admin 17 0 0 4 2017-07-12T03:55:18Z *7 admin 10 0 0 0 2017-07-12T04:42:55Z OS10# Supported Releases 10.3.1E or later Telnet server To allow Telnet TCP/IP connections to an OS10 switch, enable the Telnet server. The OS10 Telnet server uses the Debian telnetd package. By default, the Telnet server is disabled. When the Telnet server is enabled, connect to the switch using the IP address configured on the management or any front-panel port. The Telnet server configuration is persistent and is maintained after you reload the switch. To verify the Telnet server configuration, enter the show running-configuration command. Enable Telnet server OS10(config)# ip telnet server enable Disable Telnet server OS10(config)# no ip telnet server enable By default, the Telnet server is disabled on the default VRF. To configure the Telnet server to be reachable on the management VRF, use the ip telnet server vrf management command. System management 471