Dell OptiPlex 7010 Owner's Manual (Small Form Factor) - Page 15

Installing the Intrusion Switch, Memory Module Guidelines, Removing the Memory

Get Dell OptiPlex 7010 PDF manuals and user guides View all Dell OptiPlex 7010 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Installing the Intrusion Switch 1. Insert the intrusion switch into the chassis rear and slide it outward to secure it. 2. Connect the intrusion-switch cable to the system board. 3. Install the cover. 4. Follow the procedures in After Working Inside Your Computer. Memory Module Guidelines To ensure optimal performance of your computer, observe the following general guidelines when configuring your system memory: • Memory modules of different sizes can be mixed (for example, 2 GB and 4 GB), but all populated channels must have identical configurations. • Memory modules must be installed beginning with the first socket. NOTE: The memory sockets in your computer may be labelled differently depending on the hardware configuration. For example, A1, A2 or 1,2,3. • If the quad-rank memory modules are mixed with single or dual-rank modules, the quad-rank modules must be installed in the sockets with the white release levers. • If memory modules with different speeds are installed, they operate at the speed of the slowest installed memory module(s). Removing the Memory 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a) cover b) front bezel c) drive cage 3. Release the memory-retention clips on each side of the memory modules. 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
Installing the Intrusion Switch
1.
Insert the intrusion switch into the chassis rear and slide it outward to secure it.
2.
Connect the intrusion-switch cable to the system board.
3.
Install the cover.
4.
Follow the procedures in
After Working Inside Your Computer
.
Memory Module Guidelines
To ensure optimal performance of your computer, observe the following general guidelines when configuring your
system memory:
•
Memory modules of different sizes can be mixed (for example, 2 GB and 4 GB), but all populated channels must
have identical configurations.
•
Memory modules must be installed beginning with the first socket.
NOTE:
The memory sockets in your computer may be labelled differently depending on the hardware configuration.
For example, A1, A2 or 1,2,3.
•
If the quad-rank memory modules are mixed with single or dual-rank modules, the quad-rank modules must be
installed in the sockets with the white release levers.
•
If memory modules with different speeds are installed, they operate at the speed of the slowest installed
memory module(s).
Removing the Memory
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a)
cover
b)
front bezel
c)
drive cage
3.
Release the memory-retention clips on each side of the memory modules.
15