Dell OptiPlex 7010 Owner's Manual (Small Form Factor) - Page 22

Installing the Input/Output (I/O) Panel, Removing the Power Supply

Get Dell OptiPlex 7010 PDF manuals and user guides View all Dell OptiPlex 7010 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

4. Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to the right to release and remove from the computer. Installing the Input/Output (I/O) Panel 1. Insert the I/O panel into the slot on the chassis front. 2. Slide the I/O panel towards the left of the computer to secure to the chassis. 3. Tighten the screw to secure the I/O panel to the chassis. 4. Connect the I/O panel/FlyWire cable to the system board. 5. Thread the I/O panel/ FlyWire cable into the fan-shelter clip and the routing on the heat sink. 6. Install the: a) drive cage b) front bezel c) cover 7. Follow the procedures in After Working Inside Your Computer. Removing the Power Supply 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a) cover b) front bezel 22

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
4.
Remove the screw that secures the I/O panel to the chassis. Then, slide the I/O panel to the right to release and
remove from the computer.
Installing the Input/Output (I/O) Panel
1.
Insert the I/O panel into the slot on the chassis front.
2.
Slide the I/O panel towards the left of the computer to secure to the chassis.
3.
Tighten the screw to secure the I/O panel to the chassis.
4.
Connect the I/O panel/FlyWire cable to the system board.
5.
Thread the I/O panel/ FlyWire cable into the fan-shelter clip and the routing on the heat sink.
6.
Install the:
a)
drive cage
b)
front bezel
c)
cover
7.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Power Supply
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a)
cover
b)
front bezel
22