Dell OptiPlex 7010 Owner's Manual (Small Form Factor) - Page 21
Installing the Power-Switch Cable, Removing the Input/Output (I/O) Panel
View all Dell OptiPlex 7010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
4. Press in the retention clips and slide the power-switch cable out through the front of the computer. Installing the Power-Switch Cable 1. Slide the power-switch cable in through the front of the computer. 2. Secure the power-switch cable to the chassis. 3. Thread the power-switch cable into the chassis clip. 4. Connect the power-switch cable to the system board. 5. Install the: a) drive cage b) front bezel c) cover 6. Follow the procedures in After Working Inside Your Computer. Removing the Input/Output (I/O) Panel 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a) cover b) front bezel c) drive cage 3. Disconnect and un-thread the I/O panel/ FlyWire cable from the fan-shelter clip and heat sink. 21
4.
Press in the retention clips and slide the power-switch cable out through the front of the computer.
Installing the Power-Switch Cable
1.
Slide the power-switch cable in through the front of the computer.
2.
Secure the power-switch cable to the chassis.
3.
Thread the power-switch cable into the chassis clip.
4.
Connect the power-switch cable to the system board.
5.
Install the:
a)
drive cage
b)
front bezel
c)
cover
6.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Input/Output (I/O) Panel
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Remove the:
a)
cover
b)
front bezel
c)
drive cage
3.
Disconnect and un-thread the I/O panel/ FlyWire cable from the fan-shelter clip and heat sink.
21