Dell PowerConnect 2808 Getting Started Guide - Page 19
Wizard Step 1 - default ip
View all Dell PowerConnect 2808 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
• IP subnet mask • Default Gateway IP address The Setup Wizard displays the following information: Welcome to Dell Easy Setup Wizard. The Setup Wizard guides you through the initial switch configuration, and gets you up and running as quickly as possible. You can skip the setup wizard, and enter CLI mode to manually configure the switch. The system will prompt you with a default answer; by pressing enter, you accept the default. You must respond to the next question to run the setup wizard within 60 seconds, otherwise the system will continue with normal operation using the default system configuration. Would you like to enter the setup wizard (you must answer this question within 60 seconds)? (Y/N)[Y] Y NOTE: If you select not to use the Setup Wizard, you can access the Web inteface by using the default IP address/mask (192.168.2.1/255.255.255.0). NOTE: You can exit the Setup Wizard at any time by entering [Ctrl+Z]. Wizard Step 1 The following information displays: The system is not setup for SNMP management by default. To manage the switch using SNMP (required for Dell Network Manager) you can: *Setup the initial SNMP Version 2 account now *Return later and setup additional SNMP v1/v2 accounts For more information on setting up SNMP accounts, please see the user documentation. Would you like to setup the SNMP management interface now? (Y/N)[Y] Y Enter [N] to skip to Step 2. Enter [Y] to continue the Set-up wizard. The following information displays: To setup the SNMP management account you must specify the management system IP address and the "community string" or password that the particular management system uses to access the switch. The wizard automatically assigns the highest access level [Privilege Level 15] to this account. Starting and Configuring the Device 17