Dell PowerConnect M6220 Command Line Interface Guide - Page 647

Example With no optional arguments, the command displays the following information: • Admin Mode - Indicates whether or not MLD Snooping is active on the switch. • Interfaces Enabled for MLD Snooping - Interfaces on which MLD Snooping is enabled. • MLD Control Frame Count - This displays the number of MLD control frames that are processed by the CPU. • VLANs Enabled for MLD Snooping - VLANs on which MLD Snooping is enabled. When you specify an interface or VLAN, the following information displays: • MLD Snooping Admin Mode - Indicates whether MLD Snooping is active on the interface or VLAN. • Fast Leave Mode - Indicates whether MLD Snooping Fast-leave is active on the VLAN. • Group Membership Interval - Shows the amount of time in seconds that a switch will wait for a report from a particular group on a particular interface, which is participating in the VLAN, before deleting the interface from the entry. This value may be configured. • Max Response Time - Displays the amount of time the switch waits after it sends a query on an interface, participating in the VLAN, because it did not receive a report for a particular group on that interface. This value may be configured. • Multicast Router Present Expiration Time - Displays the amount of time to wait before removing an interface that is participating in the VLAN from the list of interfaces with multicast routers attached. The interface is removed if a query is not received. This value may be configured. show ipv6 mld snooping groups The show ipv6 mld snooping groups command displays the MLD Snooping entries in the MFDB table. Syntax show ipv6 mld snooping groups [{vlan vlan-id | address ipv6-multicast-address}] • vlan_id - Specifies a VLAN ID value. • ipv6-multicast-address - Specifies an IPv6 Multicast address. Default configuration This command has no default configuration. Command Mode Privileged EXEC mode. 647