Dell PowerConnect M6220 Command Line Interface Guide - Page 759

Default Configuration Enabled is the default configuration. Command Mode Router OSPF Configuration mode. User Guidelines This command has no user guidelines. Example The following example enables OSPF router mode. console(config-router)#enable exit-overflow-interval Use the exit-overflow-interval command in Router OSPF Configuration mode to configure the exit overflow interval for OSPF. When a router leaves the overflow state it can originate nondefault AS-external-LSAs. When set to 0, the router will not leave Overflow State until restarted. Use the no form of the command to return the interval to the default value. Syntax exit-overflow-interval seconds no exit-overflow-interval • seconds - Number of seconds after entering overflow state that a router will wait before attempting to leave the overflow state. (Range: 0-2147483647) Default Configuration 0 seconds is the default configuration. Command Mode Router OSPF Configuration mode. User Guidelines This command has no user guidelines. Example The following example sets the exit overflow interval for OSPF at 10 seconds. console(config-router)#exit-overflow-interval 10 759