Dell PowerEdge 4600 Rack-to-Tower Conversion Guide - Page 16
Installation, and Troubleshooting Guide, Installation and Troubleshooting Guide - power supply troubleshooting
View all Dell PowerEdge 4600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
3 Install the four metal feet: a Insert the two tabs of the metal feet into the slots on the chassis and trim panel (see Figure 1-8). b Secure the metal feet to the chassis and trim panel with four 6-32 x 0.25-inch hex-head Phillips screws (see Figure 1-8). Figure 1-8. Attaching the Metal Feet metal feet (4) tabs (2) 6-32 x 0.25-inch hex-head Phillips screws (4) 4 Position the tower bezel so that it is perpendicular to the system (see Figure 1-9). 5 Retract and lock the retaining pins in the bezel's hinge halves. 6 Rotate the retaining pins in their grooves to release the pins into their mating hinge halves. 7 Reinstall the hard drives in their labeled slots in the drive bay (see your Installation and Troubleshooting Guide for instructions). 8 Reinstall the power supplies (see your Installation and Troubleshooting Guide for instructions). 9 Close the bezel. Rack-to-Tower Conversion Guide 1-13