Dell PowerEdge 6600 Rack Installation Guide (.pdf) - Page 21
Replacing the Rack Doors
View all Dell PowerEdge 6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
2 From the front of the rack cabinet, press in on the blue release push button, lift up, and push the slide assembly approximately 1 inch back from the front vertical rail until the mounting-bracket flange and its mounting hooks disengage from the square holes in the front vertical rail (see Figure 1-10). 3 Repeat step 2 at the back of the cabinet for this slide assembly. 4 If the slide assemblies are secured with screws, remove the screws that secure the front and back mounting-bracket flanges to the vertical rails. 5 Repeat steps 1 through 3(or step 4 if screws secure the slide assemblies) for the remaining slide assembly on the other side of the rack. 6 Place the cable-management arm, slide assemblies, and all fastener hardware in a box. Label the box as a rack installation kit for the system model you removed from the rack. Replacing the Rack Doors Refer to the procedures for replacing doors in the documentation provided with your rack cabinets. This completes the tower conversion of your system. Rack-to-Tower Conversion Guide 1-17