Dell PowerEdge 7150 Rack Installation Guide - Page 10

www.dell.com | support.dell.com Figure 1-1. Rack Kit Contents cable-management arm slide assemblies with mounting brackets (2) cable tray rack template 6-32 x 0.25-inch flat-head Phillips screws (2) 6-32 x 0.25-inch hex-head taptite screws (3) Rack Requirements The rack kit is designed for use in a Dell rack with an extended-depth back door. If you have a Dell rack cabinet with a white finish, check that the back door does not contain flush-mounted glass. If it does, you will need to order a new rack door from Dell before installing your new system in the rack. NOTICE: This rack kit is intended to be installed in a Dell rack by trained service technicians. If you install the kit in any other rack, be sure that the rack meets the specifications of American National Standards Institute (ANSI)/Electronic Industries Association (EIA) standard ANSI/EIA-310-D-92, International Electrotechnical Commission (IEC) 297, and Deutsche Industrie Norm (DIN) 41494. One rack kit is required for each system that is installed in a rack. 1-2 Rack Installation Guide