Dell PowerEdge M420 Dell PowerConnect M8024-k Release Notes - Page 12

Changed Functionality in this Release This section contains commentary on significant differences from previous releases of firmware on PowerConnect switches, e.g. the PCM6348/PCM6220/PCM8024/PC8024/PC8024F switches. Dell PowerConnect series switches closely conform to networking industry standard operational capabilities and administrative interfaces. The differences below should be studied carefully as attempting to configure or operate the PowerConnect switches in the same manner as for previous releases of firmware for PowerConnect PCM6348/PCM6220/PCM8024/PC8024/PC8024F switches may lead to unexpected results.  New Web Interface The Web interface has been enhanced with new navigation feature for ease of use.  CLI Syntax Changes The CLI has changed significantly to be compatible with the PowerConnect switch standard CLI. Configurations for previous releases may not be compatible with this release and may need to be updated.  Unit/Slot/Port Naming Conventions In-band interfaces are named based on stack unit, slot, and port. Units range from 1-12. Slots range from 0-2. Ports range from 1-48. Rear panel slots are number 1 and 2. Front panel ports belong to slot 0. The service port is addressed using the out-of-band keyword.  Management VLAN Deprecated The PowerConnect series switches do not have an in-band management VLAN by default. Administrators can designate a VLAN for support of in-band management operations.  All Interfaces Default to VLAN 1 By default, all in-band interfaces are members of VLAN 1. The operator may exclude ports from VLAN 1 via configuration.  Routing Supported on VLANs Only Routing is only supported on VLAN interfaces. Routing may not be configured on a physical interface.  Assigning IP Address Enables Routing Assigning an IP address to a VLAN enables routing on the VLAN.  Service/Out-of-band Ethernet Port Defaults to DHCP Addressing By default, the service/out-of-band Ethernet port will attempt to obtain an address via DHCP. NOTE: It is recommended that administrators attach the service/out-ofband Ethernet port to a physically separate network for out-of-band network management. The service port does not offer routing or switching capabilities nor does it offer enhanced protection from DOS attacks. Configure a VLAN on one or more in-band interfaces for management of PowerConnect switches over the operational network. 10 System Firmware Version 4.1.0.6