Dell PowerEdge M420 Dell PowerConnect M8024-k Release Notes - Page 19

PowerConnect M6220/M6348/8024/8024F/M8024/M8024-k/ 7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes Summary SysUpTime is not being shown correctly during an SNMP walk (Poll interval 1sec) Log messages need to be corrected on ip dhcp snooping rate limit scenario. The show ip vlan command output is not proper after more-quit prompt is encountered, i.e. after around 16 routing interfaces Invalid error port number displayed on log message when vlan is changed to forbidden mode from access mode The banner motd XXXXX does not appear in show running-config Web page mac-vlan table too slow to load. Confused between ip default gateway and ip default route (update manual with how to set a default route). Auto Install show boot retry count line needs to be left aligned by one space. Cannot Access Optical Transceiver Diagnostics Page if Multiple Submits done prior to initial refresh completing Error messages for non-existent stack members non-informative User Impact Operator confusion regarding switch operation. Operator confusion regarding switch configuration. Inability to diagnose network issues. Operator confusion regarding switch configuration. Operator confusion regarding switch configuration. Operator confusion regarding switch configuration. Operator frustration with switch management. Operator confusion regarding switch configuration. None. Operator frustration with switch management. Operator confusion regarding switch configuration. Traffic is forwarding when IPv6 forwarding is disabled Incorrect operational state in network. A LAG member comes UP if configured individually as no shutdown, even though the port-channel's state is down Re-authenticate Now check box is not highlighted when edit check box is selected Block command is not seen in show running config through web and cli Incorrect operational state in network. Inability to configure switch. User confusion over switch operations. FDB entries are getting aged out before User confusion over switch default age-out time, when both FDB and operations. MFDB tables are full. DHCP packets forwarding is not proper to/from the trusted and un-trusted ports Incorrect operational state in network. Configuring all ports in all VLANs takes Operator frustration with switch a long time management. Workaround The correct variable is used to write SysUpTime Interface representations in log messages use unit-slot-port format. The paging has been corrected. The error message is no longer issued. All banner configuration appear in the running-config For certain browsers, paging has been implemented to speed up load times. The ip default route command is deprecated. Use the ip default route command to set a default route. The retry count alignment is corrected This is a browser dependant issue (IE 6) that is not seen in later versions. The web session recovers after doing a refresh. The user can pre-configure stack units. If the stack unit does not exist for a switch configuration operation, an error message indicating same is issued. The ipv6 forwarding command is deprecated. To disable traffic forwarding, use the no ipv6 unicast-routing in place of no ipv6 forwarding command. LAG members are placed in the blocking state for dynamic LAGs and only come up when the LAG link comes up. The Re-authenticate Now check box is highlighted when the edit check box is selected The block command is a temporary administrative assignment and is not maintained persistently in the saved or running configs. On the PCM6220, the MFDB and FDB tables are a shared resource. The user is continually sending new MFDB entries, which causes old FDB entries to be removed to make a place for the new MFDB entries. The frame flooding routing in DHCP snooping now takes into account trust status. VLAN configuration has been optimized. System Firmware Version 4.1.0.6 Page 17