Dell PowerEdge M420 Dell PowerConnect M8024-k Release Notes - Page 18

Issues Resolved The following issues from previous releases have been corrected in this release. The issues listed here may have been discovered on any of the switches listed on the title page. Summary SSH crash - memPartAlloc: block too big PC M8024 switch reset out-of-band address to none when switchports were changed Web page shows IP address as '0.0.0.0' for '1.1.1.1' routing interface. Read-Only Web page is populating all configured IP and IPv6 ACL names when we select the ACL Name. FAN LED graphic on web page needs to glow in RED when FANs are not operational (stopped). Incorrect command is being displayed in running-config, when disabled the boot host dhcp DUT crashes while configuring max dynamic vlans. Manager of the stack is changing when trying to learn maximum number of VLANs using GVRP. Switch prompts to save config data when no changes have been made Crash while RFC3918 Group Capacity test is running 'no' version of 'key' command is not implemented Password is not accepting quotation ( " ) character Incorrect warning message displayed while executing the command "boot system image1" IPV6 command displays wrong output LLDP-MED log messages showing 5 sec difference in entry age out information Dhcpv6 web issues LLDP MED application should not allow configuration of location and inventory transmit TLV's as underlying application not present User Impact Reduced switch functionality. Inability to access switch via OOB port. Operator confusion over switch operations Operator confusion regarding web page operations. Inability to determine switch status. Operator confusion regarding web page operations. Network outage possible. Operator confusion regarding switch operations. Operator confusion regarding switch operation. Network outage possible. Operator frustration with switch management. Operator confusion regarding switch configuration. Operator confusion regarding switch operation. Operator confusion regarding switch operation. Operator confusion regarding switch operation. Operator confusion regarding switch configuration. Operator confusion regarding switch configuration. Workaround Memory allocation issue is corrected and checked for memory leaks The out-of-band address is maintained over switchport changes. The web page output has been corrected. The web page has been corrected to only populate the selected entry. Web page has been corrected The running config now shows the correct configuration The PowerConnect does not crash when using maximum dynamic VLANs The stack manager does not change during learning with GVRP The switch no longer prompts to save config data if no changes have been made The PowerConnect switch runs the RFC3918 test without crashing The no key command is implemented to return the key configuration to the default. Passwords can be enclosed in quotes (contain embedded blanks). A password may not contain a quote. The accepted character set and length is documented in the CLI reference manual. The error message has been corrected to indicate that the unit selected for reboot does not exist. The IPv6 output has been corrected to remove the duplicate display lines in show ipv6 help. The LLDP timer has been updated to account for processing skew. The acceptable character sets are documented in the CLI Reference guide. Location and inventory TLVs cannot be enabled for transmission in LLDP MED. 16 System Firmware Version 4.1.0.6