Dell PowerEdge M420 Dell PowerConnect M8024-k Release Notes - Page 21

PowerConnect M6220/M6348/8024/8024F/M8024/M8024-k/ 7024/7048/7024P/7048P/7024F/7048R/7048R-RA Release Notes Summary CDP (ISDP) is active on port-channels instead of the member Ethernet interfaces. For dynamic LAGS, the ISDP information is not exchanged on the interface until the port-channel becomes active. CLI Manual Has No Index Script validation is fails when max SNTP servers are configured. Configured SYSLOG server parameters cannot be updated without deleting and re-configuring CLI will not let user configure available parameter for the given IGMP command Inconsistent behavior - using same port number for multiple services LLDP Assignment of port ID for PortDescription TLV Management ACL list needs "Match every packet" option SNMP support for Dell-LAN-TRAP-MIB User Impact User confusion over switch operations. Inability to interoperate with other switches. Workaround CDP is active on the member ports for dynamic LAGs when the LAG is active. User frustration over switch configuration. User confusion over switch configuration. User frustration over switch configuration. User frustration over switch configuration. User confusion over switch operations. User confusion over switch operations. Inability to diagnose network issues. User frustration over switch configuration. Possible security issue. User frustration over switch configuration. The CLI manual has an index Corrected CLI validation check so that existing server can be entered multiple times. Syslog server parameter can be updated in the CLI without deleting the server IGMP configuration commands can be entered in interface VLAN mode at any time Attempting to add a service with a TCP port overlapping a TCP port used by an existing service is denied with an appropriate error message. The LLDP port id TLV is supported by PowerConnect and can be displayed on peer devices New syntax has been added to the management ACL to allow the any specification for the service type. The Dell-LAN-TRAP-MIB is supported System Firmware Version 4.1.0.6 Page 19