Dell PowerEdge M520 Dell M8428-k Getting Started Guide - Page 14
Changing to full fabric mode using the Command Line Interface, Dell M8428-k hardware Reference Manual
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Changing to full fabric mode using the Command Line Interface Complete the following steps to enable NPIV mode using the CLI (The switch GUI also provides a method to change NPIV mode in the advanced menu, see the Dell M8428-k hardware Reference Manual for details). 1. Log in using the default administrative account. Login: admin Password: password 2. Enter the following command to disable the switch. switchDisable 3. Back up the switch configurations. See "Backing up the configuration" on page 15 for specifics. 4. Enter the following command to enable full fabric mode: ag --modeDisable The switch module automatically reboots and comes back online in full fabric mode. The NPIV parameters, such as port mapping and failover and failback, are automatically removed. You can enter the ag --modeShow command to ensure that the module is in NPIV mode. ag --modeShow The response should be: Access Gateway mode is NOT enabled. Changing to NPIV mode using the Command Line Interface If your converged network switch is currently configured in full fabric mode you canenable NPIV mode using the following instructions (The switch GUI also provides a method to change NPIV mode in the advanced menu, see the Dell M8428-k Hardware Reference Manual for details): 1. Log in using the default administrative account. Login: admin Password: password 2. Enter the following command to disable full fabric mode. switchDisable 3. Back up the switch configurations. See "Backing up the configuration" on page 15 for specifics. 4. Enter the following command to enable NPIV mode: ag --modeEnable The switch module automatically reboots and comes back online in NPIV mode using a factory default F_Port to N_Port mapping. 5. You can enter the ag --modeShow command to ensure that the module is in NPIV mode. ag --modeShow The response should be: Access Gateway mode is enabled. 14 of 192 Dell M8428-k Getting Started Guide MHWKY A01