Dell PowerEdge M520 Dell M8428-k Getting Started Guide - Page 3
Overview, Unpacking and installing the converged network switch
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Overview This Getting Started Guide is intended as an overview to help experienced installers unpack, install, and configure the Dell M8428-k quickly. For detailed installation and configuration instructions, see the Dell M8424-k Hardware Reference Manual. NOTE Throughout this document, the Dell M8428-k is referred to as the converged network switch or the switch module. FIGURE 1 Port Side of M8428-k Unpacking and installing the converged network switch If the converged network switch is installed in the blade server enclosure that is shipped to you, skip this section. This section applies when installing a new module in an empty I/O module slot or when replacing an existing converged network switch. Perform the following steps to remove the switch module from its shipping package. 1. Open the shipping box and inspect the contents, making sure that nothing is missing or damaged. Do not insert a damaged converged network switch into the blade server enclosure. If the switch module appears to be damaged, contact your sales representative before proceeding. 2. Remove the Getting Started Guide containing regulatory statements from on top of the switch module. 3. Remove the switch module from the box. 4. Be sure that you have taken the necessary precautions for electrostatic sensitivity; then break the warning seal. 5. Slide the switch module out of the antistatic sleeve and inspect it carefully for any obvious defects or shipping damage. 6. Remove the orange colored protective connector cover from the back of the switch module (pull). 7. Install the I/O module in the M1000e enclosure. a. Lift the handle release latch and open the I/O module handle. b. Slide the module into the appropriate I/O slot of the M1000e enclosure. c. Close the handle until it snaps securely into place and the module is fully seated. Dell M8428-k Getting Started Guide MHWKY A01 3 of 192