Dell PowerEdge M520 Brocade M5424 Blade Server SAN I/O Module Hardware Referen - Page 35
Access Gateway Mode default port mapping, Processor and memory specifications
View all Dell PowerEdge M520 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
SAN I/O Module specifications Appendix A This appendix provides product specifications and regulatory compliance as a handy reference. Access Gateway Mode default port mapping The M5424 SAN I/O Module can contain 24 total ports. Of these, F_Ports are ports 1-16 and N_Ports are ports 0 and 17-23. In Access Gateway mode, the SAN I/O Module F_Ports are mapped to N_Ports. This following lists the factory-default F_Port to N_Port mapping for Access Gateway mode. Since the SAN I/O Module is shipped with Dynamic Ports on Demand (DPOD) enabled, any out of the 24 ports can be enabled. Therefore this mapping applies for 12 active ports or, if POD licensing is enabled, for 24 ports. For more information on changing port mapping and managing ports in Access Gateway Mode, refer to the Access Gateway Administrator's Guide. • 17-20 as N_Port with failover enabled, failback enabled • 0, 21-23 as N_Port with failover enabled, failback enabled • 1, 2 mapped to 17 • 3, 4 mapped to 18 • 5, 6 mapped to 19· • 7, 8 mapped to 20 • 9, 10 mapped to 21· • 11, 12 mapped to 22· • 13, 14 mapped to 23· • 15, 16 mapped to 0 Processor and memory specifications The processor and memory installed in the SAN I/O Module are shown in Table 5. TABLE 5 Memory Specifications Memory Type Value PowerPC 440EPX processor SDRAM Boot flash Compact flash 667 MHz 512 MB DDR2 - for system memory at 64 bits wide with 8 ECC operating at 166 MHz 4 MB 512 MB M5424 SAN I/O Module Hardware Reference Manual 25 53-1001082-01