Dell PowerEdge M520 Brocade 4424 Blade Server SAN I/O Module Hardware Referenc - Page 29

Chapter Operating the SAN I/O Module 3 This chapter describes the operation and interoperability of the SAN I/O Module. Interoperability The SAN I/O Module supports interoperability for the following functions: • link initialization • principal SAN I/O Module selection • routing (FSPF) • Simple Name Service • state change notification soft WWN zoning SNMP facilities translative mode (private target support on fabrics) trunking (between two Brocade switches) Advanced Performance Monitoring Port negotiation The SAN I/O Module has been designed to be highly interoperable. It supports 1 Gbit/sec, 2 Gbit/sec, and 4 Gbit/sec transmit and receive rates with autonegotiation. The actual data signaling rate used on a port is automatically sensed and set to the rate supported by the device or devices attached to the port. If the SAN I/O Module is connected to a device, but is unable to negotiate the signaling rate, the operator can manually set the speed of each port through the management interfaces. The SAN I/O Module is compliant with current Fibre Channel standards, including most current-generation switch N_Ports, NL_Ports, and E_Ports as well as host adapters, Redundant Array of Independent Disks (RAID) storage devices, hubs, Fibre-SCSI bridge devices, and older switch families. 4424 Blade Server SAN I/O Module Hardware Reference Manual 53-0000571-01 19