Dell PowerEdge M710HD Fabric OS Message Reference - Page 594

90 SEC-1075 Probable Cause Indicates a security command was run on a switch that is not allowed to run it either because it is in non-secure mode or because it does not have the required fabric configuration server (FCS) privilege. Recommended Action If a security operation that is not allowed in non-secure mode is attempted, do not perform the operation in non-secure mode. In secure mode, run the command from a switch that has required privilege, that is, either a backup FCS or primary FCS. Severity ERROR SEC-1075 Message , [SEC-1075], ,, ERROR, , Fail to new policy set on all switches. Probable Cause Indicates there has been a corruption during the distribution of the security database. This can only occur when the primary fabric configuration server (FCS) is distributing the security database to the other switches in the fabric and local validation finds that there is an error in the security database. This is a rare occurrence. Recommended Action Run the secFabricShow command to verify that the fabric is still consistent. All the switches should be in the ready state. If a switch is in the error state, the database might not be correctly updated for that specific switch. Severity ERROR SEC-1076 Message , [SEC-1076], ,, ERROR, , NoNodeWWNZoning option has been changed. Probable Cause Indicates the NoNodeWWNZoning option has been changed. If the option is turned on, a zone member can be added using node WWNs, but the member will not be able to communicate with others nodes in the zone. Recommended Re-enable the current zone configuration for the change to take effect. Action Severity ERROR SEC-1077 Message , [SEC-1077], ,, ERROR, , Failed to activate new policy set on all switches. Probable Cause Indicates the policy could not be activated. Possible reasons that the policy could not be activated include not enough memory or a busy switch. Recommended Run the secFabricShow command to verify that all switches in the fabric are in the ready state. Action Retry the command when all switches are ready. 518 Fabric OS Message Reference 53-1001767-01