Dell PowerEdge M710HD Fabric OS Message Reference - Page 611

90 SEC-1155 Probable Cause Indicates that either the defined or the active policy could not be updated. If the policy database is very large, it might not be able to change the index/area because the new policy database exceeds the maximum size. This message can also be caused when the switch is short of memory. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Reduce the size of the policy database. Action Severity INFO SEC-1155 Message , [SEC-1155], ,, INFO, , PID change failed: . Probable Cause Indicates that either the defined or active policy was too large after modifying the index/area ID. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Reduce the size of the specified policy database. Action Severity INFO SEC-1156 Message , [SEC-1156], ,, INFO, , Change failed: . Probable Cause Indicates the security daemon is busy. The status values can be defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Action For the first reject, wait a few minutes and then resubmit the transaction. Fabric-wide commands might take a few minutes to propagate throughout the fabric. Make sure to wait a few minutes between executing commands so that your commands do not overlap in the fabric. Severity INFO SEC-1157 Message , [SEC-1157], ,, INFO, , PID Change failed: . Probable Cause Indicates the provisioning resources for a security policy failed due to low memory or internal error. The status values can be either defined, active, or both. A negative value means that a policy set was failed by the daemon. Recommended Retry the failed command. Action Fabric OS Message Reference 535 53-1001767-01