Dell PowerEdge MX740c EMC PowerEdge MX7000 Enclosure Installation and Service - Page 40

Removing a module from Fabric A or B slot

Page 40 highlights

2. Remove the module from Fabric A or B slot. Steps 1. Align and insert the blank in the empty slot. 2. Push the blank, until it locks into place. Figure 29. Installing a blank in Fabric A or B slot Removing a module from Fabric A or B slot Prerequisites 1. Follow the safety guidelines listed in Safety instructions. 2. Disconnect the cables that are connected to the modules. Steps 1. Press the orange release button on the module to open the release levers. 2. Hold the release levers, and pull the module out of the enclosure. NOTE: Ensure that you install an IOM blank if you are removing a module permanently. 40 Installing and removing system components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63

2.
Remove the module from Fabric A or B slot
.
Steps
1.
Align and insert the blank in the empty slot.
2.
Push the blank, until it locks into place.
Figure 29. Installing a blank in Fabric A or B slot
Removing a module from Fabric A or B slot
Prerequisites
1.
Follow the safety guidelines listed in
Safety instructions
.
2.
Disconnect the cables that are connected to the modules.
Steps
1.
Press the orange release button on the module to open the release levers.
2.
Hold the release levers, and pull the module out of the enclosure.
NOTE:
Ensure that you install an IOM blank if you are removing a module permanently.
40
Installing and removing system components