Dell PowerEdge PDU Metered LCD Dell PowerEdge 2420 Rack Installation Guide - Page 15
the hinge body to the rack, and place the bolts with the hinge pin, Using the 4-mm Allen wrench
![]() |
View all Dell PowerEdge PDU Metered LCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
3 Reverse the top hinge body. a Pull the hinge pin upward slightly so that you can access the retention clip (see Figure 1-5). Figure 1-5. Removing the Front-Door Hinges 1 6 2 5 4 3 1 hinge post 3 bottom hinge 5 retention clip 2 top hinge body 4 hinge pin 6 body spring b Using the needle-nose pliers, remove the retention clip, and then slide the hinge pin out of the hinge body. c Remove the hinge spring from the hinge body. d Place the hinge pin, retention clip, and spring in a safe location. e Using the 4-mm Allen wrench, remove the Allen bolts that secure the hinge body to the rack, and place the bolts with the hinge pin, retention clip, and body spring. f Rotate the hinge body 180 degrees so that the hinge-pin holes are now on the right side of the hinge body (see Figure 1-6). Installation Guide 13
![](/manual_guide/products/dell-poweredge-2410-dell-poweredge-2420-rack-installation-guide-0bae665/15.png)