Dell PowerEdge PDU Metered LCD Dell PowerEdge 2420 Rack Installation Guide - Page 22
Installing the Rack Stabilizer Feet, Remove the plastic fasteners attached to the stabilizer feet.
![]() |
View all Dell PowerEdge PDU Metered LCD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installing the Rack Stabilizer Feet WARNING: Installing systems in a rack without the front and side stabilizer feet installed could cause the rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore, always install the stabilizer feet before installing components in the rack. Installing the Front Stabilizer Feet 1 Open the front door. 2 Reach into the rack and pull up firmly on each stabilizer to detach them from the frame. 3 Remove the plastic fasteners attached to the stabilizer feet. 4 Position each front stabilizer foot against the base of the rack frame and align its holes with the corresponding holes in the frame. 5 Use the provided bolts, washers, and cage nuts to secure each foot to the rack as shown in Figure 1-11. Figure 1-11. Installing the Front Stabilizer Feet 1 1 front stabilizer foot (2) 20 Installation Guide
![](/manual_guide/products/dell-poweredge-2410-dell-poweredge-2420-rack-installation-guide-0bae665/22.png)