Dell PowerEdge R250 Integrated Remote Access Controller 9 Attribute Registry - Page 346

the Terminal. key sequences are mapped to on the Terminal, where x is any letter key, and X is the upper case of that key. Legal Values ● Vt100Vt220 ● Ansi Default Value Not Applicable Write Privilege Server Control License Required iDRAC Express or iDRAC Enterprise Dependency Not applicable BIOS.SerialCommSettings.ExtSerialConnector (Read or Write) Description Use this field to associate the External Serial Connector to Serial Device 1, Serial Device 2, or the Remote Access Device. Note: Only Serial Device 2 can be used for Serial Over LAN. Configuring the External Serial Connector to Serial Device 1 allows independent use of Serial Device 1 while Serial Device 2 can be used for Serial Over LAN. Please see the User's Guide for the various operating modes available. Not supported on blades. Legal Values ● Serial1 ● Serial2 ● RemoteAccDevice Default Value Not Applicable Write Privilege Server Control License Required iDRAC Express or iDRAC Enterprise Dependency Not applicable BIOS.SerialCommSettings.FailSafeBaud (Read or Write) Description If the BIOS fails to determine the baud rate automatically, then it will use the baud rate specified by this field. Legal Values ● 115200 ● 57600 ● 19200 ● 9600 Default Value Not Applicable Write Privilege Server Control License Required iDRAC Express or iDRAC Enterprise Dependency Not applicable BIOS.SerialCommSettings.RedirAfterBoot (Read or Write) Description Legal Values Default Value Write Privilege Determines whether console redirection is enabled when the operating system is loaded. ● Enabled ● Disabled Not Applicable Server Control 346 BIOS Attributes