Dell PowerEdge R250 Integrated Remote Access Controller 9 Attribute Registry - Page 862

NIC.ConfigureFormn.PortNumber (Read Only) Description Port that the partition belongs to. Replace n with the number of the partition. Legal Values None Default Value None Write Privilege None License Required iDRAC Express or iDRAC Enterprise Dependency Not Applicable NIC.ConfigureFormn.SVID (Read or Write) Description When Switch Dependent Partitioning (SDP) is enabled,each partition will be assigned a pre-set Switch VLAN Identifier (SVID).The partitions are available for mapping to uplink ports at server I/O Module (IOM) as part of partition zoning. All packets sent from the switch to the NIC must be S-tagged when in SDP mode is enabled. Non-tagged packets will be dropped. When SDP is disabled SVID will be greyed out or disabled. There will be an instance of this attribute for each partition.Replace n with the number of the partition.The default value shall be number of the partitioning starting from 1001. Legal Values None Default Value 1001,1002,1003,1004 Write Privilege None License Required iDRAC Express or iDRAC Enterprise Dependency Not Applicable NIC.ConfigureFormn.SVLanId (Read or Write) Description Specify the value of the S-VLAN ID to be used by the partition for all traffic when operating in the Advanced NPar mode. The S-VLAN ID must be unique per partition and in the range from 3 to 4094. NOTE : This attribute shall only be implemented when Advanced NPar is supported. Legal Values None Default Value Partition number + 2 Write Privilege None License Required iDRAC Express or iDRAC Enterprise Dependency Not Applicable NIC.ConfigureFormn.VirtFIPMacAddr (Read or Write) Description Legal Values Default Value Write Privilege Programmatically assignable FIP-MAC address for FCoE. Virtual addresses written will also generate corresponding VWWNN and VWWPN addresses as defined in Y741D. Replace n with the number of the partition. The supported method of reverting to the permanent MAC address is by writing 0's as the virtual address. If the virtual address has not been set or if it has been cleared by the defined method, its value shall be returned as 0's. If supported, the current address value should be readable at all times, irrespective of feature and partition enablement. None 00:00:00:00:00:00 None 862 NIC Attributes