Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 159
tdr-cable-test
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Command Modes INTERFACE Command History Version 8.3.17.0 Supported on M I/O Aggregator Usage Information This command is found on the 1000/10000 Base-T Ethernet interfaces. When you enable auto, the system performs and automatic discovery to determine the optics installed and configure the appropriate speed. When you configure a speed for the 1000/10000 interface, you should confirm name command setting. Both sides of the link should have auto-negotiation either enabled or disabled. For speed settings of 1000 or auto, the software sets the link to auto-negotiation and you cannot change that setting. In FTOS, the command speed 1000 is an exact equivalent of speed auto 1000 in IOS. Related Commands name Enables or disables auto-negotiation on an interface. tdr-cable-test Test the condition of copper cables on 100/1000/10GBase-T modules. Syntax tdr-cable-test interface Parameters interface Enter the keyword TenGigabitEthernet followed by the slot/port information for the 100/1000/10GBase-T Ethernet interface. Defaults none Command Modes EXEC Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator The interface must be enabled to run the test or an error message is generated: FTOS#tdr-cable-test tengigabitethernet 5/2 Related Commands %Error: Interface is disabled TenGIG 5/2 show tdr Displays the results of the TDR test. Interfaces | 157