Dell PowerEdge XL 5133-4 Dell PowerEdge FTOS Command Line Reference Guide for - Page 166
management route, show hosts
View all Dell PowerEdge XL 5133-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 166 highlights
www.dell.com | support.dell.com Usage Using the following example of a static route: Information ip route 33.33.33.0 /24 tengigabitethernet 0/0 172.31.5.43 • The software installs a next hop that is not on the directly connected subnet but which recursively resolves to a next hop on the interface's configured subnet. In the example, if gig 0/0 has ip address on subnet 2.2.2.0 and if 172.31.5.43 recursively resolves to 2.2.2.0, FTOS installs the static route. • When the interface goes down, FTOS withdraws the route. • When the interface comes up, FTOS re-installs the route. • When recursive resolution is "broken," FTOS withdraws the route. • When recursive resolution is satisfied, FTOS re-installs the route. Related Commands show ip route Views the switch routing table. management route Configure a static route that points to the Management interface or a forwarding router. Syntax Parameters management route {ipv4-address}/mask {forwarding-router-address | managementethernet} {ipv4-address}/mask forwarding-router-address managementethernet Enter an IPv4 address (A.B.C.D) followed by the prefix-length for the IP address of the management interface. Enter an IPv4 address of a forwarding router. Enter the keyword managementethernet for the Management interface. Defaults Not configured. Command Modes CONFIGURATION Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol route) is preferred over the Management Static route. Also, Management static routes and the Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4 management routes. This command manages both tables. show hosts View the host table and DNS configuration. Syntax show hosts Command Modes EXEC EXEC Privilege Command History Version 8.3.17.0 Supported on M I/O Aggregator 164 | IPv4 Routing