Dell PowerVault DL4000 Dell PowerVault DL4000 Backup To Disk Appliance - Power - Page 7

Connecting The Storage Enclosure To The PowerVault DL4000 System - manual

Get Dell PowerVault DL4000 PDF manuals and user guides View all Dell PowerVault DL4000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

Figure 1. Setting the PowerVault MD1200 Storage Enclosure Configuration Switch 1. configuration switch Connecting The Storage Enclosure To The PowerVault DL4000 System Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the PowerVault DL4000 system to the primary Enclosure Management Module (EMM) SAS In port of the storage enclosure. For more information, see the figure below. Figure 2. Connecting the SAS Cable From the PowerVault DL4000 System to the PowerVault MD1200 Storage Enclosure Connecting The Cable Management Arm (Optional) If the appliance includes a cable management arm (CMA), locate the CMA Installation Instructions that shipped with the CMA kit and follow the instructions to install the CMA. Turning On The DL Backup To Disk Appliance After cabling the appliance, turn on the MD1200 storage enclosure, and then turn on the PowerVault DL4000 system. NOTE: It is recommended that you connect the appliance to an uninterrupted power supply (UPS) for maximum reliability and availability. For more information, see your system's Owner's Manual at dell.com/support/manuals. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
Figure 1. Setting the PowerVault MD1200 Storage Enclosure Configuration Switch
1. configuration switch
Connecting The Storage Enclosure To The PowerVault DL4000 System
Connect the data cable from the PowerEdge RAID Controller (PERC) installed in the PowerVault DL4000 system to the
primary Enclosure Management Module (EMM) SAS
In
port of the storage enclosure. For more information, see the
figure below.
Figure 2. Connecting the SAS Cable From the PowerVault DL4000 System to the PowerVault MD1200 Storage Enclosure
Connecting The Cable Management Arm (Optional)
If the appliance includes a cable management arm (CMA), locate the CMA
Installation Instructions
that shipped with the
CMA kit and follow the instructions to install the CMA.
Turning On The DL Backup To Disk Appliance
After cabling the appliance, turn on the MD1200 storage enclosure, and then turn on the PowerVault DL4000 system.
NOTE:
It is recommended that you connect the appliance to an uninterrupted power supply (UPS) for maximum
reliability and availability. For more information, see your system's
Owner's Manual
at
dell.com/support/manuals
.
7