Dell PowerVault NX3100 Hardware Owner's Manual - Page 127
Installing the System Board, Replace the expansion-card riser. See Installing an Expansion-Card Riser
View all Dell PowerVault NX3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Installing the System Board CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1 Unpack the new system board. 2 Remove the labels from the processor shield and affix them to the system identification panel on the front of the system. See Figure 1-1. 3 Holding the system board by the edges, lower the system board into the chassis. CAUTION: Do not lift the system board assembly by grasping a memory module, processor, or other components. 4 Slightly lift up the front of the system board and maneuver the system board to the bottom of the chassis until it lays completely flat. 5 Push the system board toward the back of the chassis until the board is in place. 6 Tighten the nine screws that secure the system board to the chassis. See Figure 3-26. 7 Transfer the processors to the new system board. See "Removing a Processor" on page 107 and "Installing a Processor" on page 111. 8 Remove the memory modules and transfer them to the same locations on the new board. See "Removing Memory Modules" on page 89 and "Installing Memory Modules" on page 87. 9 Connect the cables to the system board. See Figure 6-1 for the locations of the connectors on the system board. 10 Replace the expansion-card riser. See "Installing an Expansion-Card Riser" on page 97. 11 Install all expansion cards. See "Installing an Expansion Card" on page 92. 12 If applicable, reinstall the storage controller card. See "Installing the Storage Controller Card" on page 100. After connecting the SAS cables to the controller, make sure to place the cables under the guide on the end of riser 1. Installing System Components 127