Dell PowerVault NX3100 Hardware Owner's Manual - Page 90
Expansion Cards and Expansion-Card Risers, Expansion Card Installation Guidelines
View all Dell PowerVault NX3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
5 Press down and out on the ejectors on each end of the socket until the memory module pops out of the socket. See Figure 3-12. Handle each memory module only on either card edge, making sure not to touch the middle of the memory module. 6 Replace the cooling shroud. See "Installing the Cooling Shroud" on page 69. 7 Close the system. See "Closing the System" on page 67. 8 Reconnect the system and peripherals to their power sources, and turn them on. Expansion Cards and Expansion-Card Risers Your system supports up to four PCI Express (PCIe) expansion cards installed in connectors on an expansion-card riser. Depending on the configuration, your system may have either riser 1 or riser 2: • Expansion-card riser 1 provides three x4 Gen2 PCIe expansion-card slots and one x8 Gen2 PCIe expansion-card slot. • Expansion-card riser 2 provides one x4 Gen2 PCIe expansion-card slot and one x16 Gen2 PCIe expansion-card slot. CAUTION: Expansion cards can only be installed in the slots on the expansion-card riser. Do not attempt to install expansion cards directly into the riser connector on the system board. Expansion Card Installation Guidelines • The expansion-card slots support full-height, half-length cards. • The expansion-card slots are hot-swappable. • PCI Express Generation 2 expansion cards are supported in all the slots. 90 Installing System Components