Dell PowerVault NX3100 Hardware Owner's Manual - Page 32
Plug & Play, Quad rank DIMM
View all Dell PowerVault NX3100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Message Causes Corrective Actions Plug & Play Configuration Error. Error encountered in initializing PCIe device; faulty system board. Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure 6-1 for jumper location. If the problem persists, see "Troubleshooting Expansion Cards" on page 143. Quad rank DIMM detected after single rank or dual rank DIMM in socket. Invalid memory configuration. Ensure that the memory modules are installed in a valid configuration. See "General Memory Module Installation Guidelines" on page 83. Read fault. Requested sector not found. The operating system cannot Replace the optical medium, read from the hard drive, USB medium, or USB optical drive, or USB device, device. Ensure that the USB the system could not find a cables, SAS/SATA backplane particular sector on the disk, cables, or optical drive cables or the requested sector is are properly connected. defective. See "Troubleshooting a USB Device" on page 130 or "Troubleshooting a Hard Drive" on page 140, for the appropriate drive(s) installed in your system. SATA Port x device not found. There is no device connected Information only. to the specified SATA port. 32 About Your System