Dell S4148U-ON EMC PowerSwitch S4100–ON Series Installation Guide M - Page 41
Before you install an OS
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
8 Before you install an OS After powering on the S4100-ON Series switch, it goes through a power-on self-test (POST). POST runs every time the switch is initialized and checks the hardware components to determine if the switch is fully operational before booting. After POST, the switch uses the Grub bootloader. To select an entry, use the up and down arrow keys. Press Enter to select an operating software (OS) or enter e to edit the commands before booting. Enter c for a command line. The selected entry runs automatically in the operating system. Grub bootloader example GNU GRUB version 2.02~beta2+e4a1fe391 |*ONIE: Install OS | | ONIE: Rescue | | ONIE: Uninstall OS | | ONIE: Update ONIE | | ONIE: Embed ONIE | | EDA-DIAG | | | | | | | | | | | | | Your switch comes with ONIE installed. NOTE: To access ONIE, use the RJ-45 console port. ONIE example ONIE: Install OS For downloading and installing an OS from a URL Starts ONIE with ONIE Discovery Service (factory default boot) ONIE: Rescue Starts ONIE without ONIE Discovery Service Useful for running Diagnostics manually ONIE: Uninstall OS Restore to factory defaults erases any installed OS ONIE: Update ONIE For downloading and updating ONIE from a URL ONIE: Embed ONIE For downloading and updating ONIE from a URL and erases any installed OS During the initial setup, the switch boots to ONIE Install. ONIE Install boots with ONIE Discovery to the console (ONIE:). NOTE: For more information, see the Open Networking Hardware Diagnostic Guide found at the following sites: ● S4148F-ON, S4148T-ON, S4148FE-ON: www.dell.com/support/S4148F-ON/S4148T-ON/S4148FE-ON ● S4128T-ON, S4148T-ON: www.dell.com/support/S4128T-ON/S4148T-ON ● S4148U-ON: www.dell.com/support/S4148U Before you install an OS 41