Dell S6000 Dell Networking System Getting Started Guide - Page 23

Two-Post Center-Mount Configuration, Four-Post Threaded Configuration

Get Dell S6000 PDF manuals and user guides View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Two-Post Center-Mount Configuration: 1 Slide the plunger bracket rearward until it clicks into place and secure the bracket to the front post flange with two user-supplied screws. Refer to Figure 4-3, item 1. Figure 4-3. Two-Post Center-Mount Configuration 2 Slide the back bracket towards the post and secure it to the post flange with two user-supplied screws. Refer to Figure 4-3, item 2. 3 Repeat this procedure for the second rail. Four-Post Threaded Configuration: 1 For this configuration, remove the flange ear castings from each end of the ReadyRails assemblies. Use a Torx driver to remove the two screws from each flange ear and remove each casting. Refer to Figure 4-4, item 1. Retain the castings for future rack requirements. 2 For each rail, attach the front and rear flanges to the post flanges with two user-supplied screws at each end. Refer to Figure 4-4, item 2. Installation 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
Installation
19
Two-Post Center-Mount Configuration:
1
Slide the plunger bracket rearward until it clicks into place and secure the
bracket to the front post flange with two user-supplied screws. Refer
to
Figure 4-3
, item 1.
Figure 4-3.
Two-Post Center-Mount Configuration
2
Slide the back bracket towards the post and secure it to the post flange with
two user-supplied screws. Refer to
Figure 4-3
, item 2.
3
Repeat this procedure for the second rail.
Four-Post Threaded Configuration:
1
For this configuration, remove the flange ear castings from each end of the
ReadyRails assemblies. Use a Torx driver to remove the two screws from
each flange ear and remove each casting. Refer to
Figure 4-4
, item 1. Retain
the castings for future rack requirements.
2
For each rail, attach the front and rear flanges to the post flanges with two
user-supplied screws at each end. Refer to
Figure 4-4
, item 2.