Dell S6000 Dell Networking System Getting Started Guide - Page 35

To view which interfaces are tagged or untagged and to view which VLAN the interfaces belong, use the show vlan command. To view just the interfaces that are in Layer 2 mode, use the show interfaces switchport command in EXEC Privilege mode or EXEC mode. To tag frames leaving an interface in Layer 2 mode, assign that interface as tagged to a port-based VLAN to tag it with that VLAN ID. To tag interfaces, follow these steps. Step Task Command Syntax Command Mode 1 Access the interface vlan vlan-id INTERFACE VLAN mode of the VLAN to which you want to assign the interface. CONFIGURATION 2 Enable an interface to tagged interface include the IEEE 802.1Q tag header. This command is available only in VLAN interfaces. INTERFACE To move untagged interfaces from the Default VLAN to another VLAN, use the untagged command: To move untagged interfaces, follow these steps. Step Task Command Syntax Command Mode 1 Access the interface vlan vlan-id INTERFACE VLAN mode of the VLAN to which you want to assign the interface. CONFIGURATION 2 Configure an interface untagged interface as untagged. This command is available only in VLAN interfaces. INTERFACE Installing the Software 31