Dell S6000 Dell Networking System Getting Started Guide - Page 31
Default Configuration, Configuring Layer 2 (Data Link) Mode, Configuring a Host Name
View all Dell S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Default Configuration A version of FTOS is pre-loaded onto the S6000 system; however, the system is not configured when you power up for the first time (except for the default host name, which is FTOS). You must configure the system using the CLI. Configuring Layer 2 (Data Link) Mode To enable Layer 2 data transmissions through an individual interface, use the switchport command in INTERFACE mode. You cannot configure switching or Layer 2 protocols such as spanning tree protocol (STP) on an interface unless the interface has been set to Layer 2 mode. To configure Layer 2 mode, follow these steps. Step Task Command Syntax 1 Enable the interface. no shutdown 2 Place the interface in switchport Layer 2 (switching) mode. Command Mode INTERFACE INTERFACE To view the interfaces in Layer 2 mode, use the show interfaces switchport command in EXEC mode. Configuring a Host Name The host name appears in the prompt. The default host name is FTOS. Host names must start with a letter, end with a letter or digit, and must have characters, letters, digits, and hyphens in the string. To configure a host name, follow this step. Task Command Syntax Create a new host name. hostname name Command Mode CONFIGURATION Installing the Software 27