Dell Vostro 13 Service Manual - Page 20

Back to Contents Page Display Closure Sensor Dell™ Vostro™ V13 Service Manual WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. Removing the Display Closure Sensor NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below. 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the ExpressCard, if applicable. 3. Remove the SD card, if applicable. 4. Remove the base cover. 5. Remove the battery. 6. Remove the screw that secures the display closure board to the computer. 7. Carefully slide the white latch to disconnect the flex cable that connects the display closure sensor to the computer. 8. Remove the display closure sensor from the computer. Replacing the Display Closure Sensor To replace the display closure sensor, perform the above steps in reverse order. Back to Contents Page