Dell Vostro 200 Owner's Manual - Page 150

Align the optical drive panel insert along the edges of the empty slot for the optical drive. Push until the insert is locked in place. NOTE: To comply with FCC regulations, it is recommended that you replace the drive panel insert whenever the optical drive is removed from the computer. Battery Replacing the Battery CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis. A coin-cell battery maintains computer configuration, date, and time information. The battery can last several years. If you have to repeatedly reset time and date information after turning on the computer, replace the battery. CAUTION: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. To replace the battery: 1 Record all the screens in system setup (see "System Setup" on page 174) so that you can restore the correct settings in Step 9. 2 Follow the procedures in "Before You Begin" on page 101. 3 Remove the computer cover (see "Removing the Computer Cover" on page 103). 4 Locate the battery socket (see "System Board Components" on page 106). 5 Carefully press the battery release lever away from the battery and the battery will pop out. 6 Insert the new battery into the socket with the side labeled "+" facing up, then snap the battery into place. 150 Removing and Installing Parts