Dell Vostro 270 Owner's Manual - Page 44

Error Messages HARD-DISK DRIVE READ FAILURE INSERT BOOTABLE MEDIA INVALID CONFIGURATION INFORMATION-PLEASE RUN SYSTEM SETUP PROGRAM KEYBOARD CLOCK LINE FAILURE KEYBOARD CONTROLLER FAILURE KEYBOARD DATA LINE FAILURE KEYBOARD STUCK KEY FAILURE LICENSED CONTENT IS NOT ACCESSIBLE IN MEDIADIRECT MEMORY ADDRESS LINE FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE MEMORY ALLOCATION ERROR MEMORY DOUBLE WORD LOGIC FAILURE AT ADDRESS, READ VALUE EXPECTING VALUE Description drive. Run the Hard Disk Drive tests in the Dell Diagnostics. The hard drive may be defective. Shut down the computer, remove the hard drive, and boot the computer from a optical. Then, shut down the computer, reinstall the hard drive, and restart the computer. If the problem persists, try another drive. Run the Hard Disk Drive tests in the Dell Diagnostics. The operating system is trying to boot to non-bootable media, such as a floppy disk or optical drive. Insert bootable media. The system configuration information does not match the hardware configuration. The message is most likely to occur after a memory module is installed. Correct the appropriate options in the system setup program. For external keyboards, check the cable connection. Run the Keyboard Controller test in the Dell Diagnostics. For external keyboards, check the cable connection. Restart the computer, and avoid touching the keyboard or the mouse during the boot routine. Run the Keyboard Controller test in the Dell Diagnostics. For external keyboards, check the cable connection. Run theKeyboard Controller test in the Dell Diagnostics. For external keyboards or keypads, check the cable connection. Restart the computer, and avoid touching the keyboard or keys during the boot routine. Run the Stuck Key test in the Dell Diagnostics. Dell MediaDirect cannot verify the Digital Rights Management (DRM) restrictions on the file, so the file cannot be played. A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them. The software you are attempting to run is conflicting with the operating system, another program, or a utility. Shut down the computer, wait 30 seconds, and then restart it. Try to run the program again. If the error message still appears, see the software documentation. A memory module may be faulty or improperly seated. Reinstall the memory modules and, if necessary, replace them. 44