Dell Vostro 5590 Service Manual - Page 42

Installing the touchpad

Get Dell Vostro 5590 PDF manuals and user guides View all Dell Vostro 5590 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

5. Lift the latch and disconnect the touchpad cable from the connector on the system board. 6. Peel the adhesive that secures the touchpad to the palmrest and keyboard assembly. 7. Remove the four (M2x2) screws that secure the touchpad to the palmrest and keyboard assembly. 8. Lift the touchpad out of the computer. Installing the touchpad Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the touchpad and provides a visual representation of the installation procedure. Steps 1. Locate the touchpad slot on your computer. 2. Align and place the touchpad into the slot on your computer. 3. Replace the four (M2x2) screws to secure the touchpad to the plamrest. 4. Connect the touchpad cable to the connector on the system board and secure the latch. 42 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
5.
Lift the latch and disconnect the touchpad cable from the connector on the system board.
6.
Peel the adhesive that secures the touchpad to the palmrest and keyboard assembly.
7.
Remove the four (M2x2) screws that secure the touchpad to the palmrest and keyboard assembly.
8.
Lift the touchpad out of the computer.
Installing the touchpad
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the touchpad and provides a visual representation of the installation procedure.
Steps
1.
Locate the touchpad slot on your computer.
2.
Align and place the touchpad into the slot on your computer.
3.
Replace the four (M2x2) screws to secure the touchpad to the plamrest.
4.
Connect the touchpad cable to the connector on the system board and secure the latch.
42
Removing and installing components