Dell Vostro 5590 Service Manual - Page 58

Installing the display assembly

Get Dell Vostro 5590 PDF manuals and user guides View all Dell Vostro 5590 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 58 highlights

Steps 1. Peel the tape that secures the display cable connector to the system board. 2. Open the latch and disconnect the display cable from the system board. 3. Remove the four (M2.5x2.5 (Big head)) screws and two (M2x3) screws that secure the left and right display hinges to the chassis of your computer. 4. Open the display hinges at an angle of 90 degrees. 5. Gently slide and lift the palmrest assembly off the display assembly. Installing the display assembly Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the component and provides a visual representation of the installation procedure. 58 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
Steps
1.
Peel the tape that secures the display cable connector to the system board.
2.
Open the latch and disconnect the display cable from the system board.
3.
Remove the four (M2.5x2.5 (Big head)) screws and two (M2x3) screws that secure the left and right display hinges to the chassis of
your computer.
4.
Open the display hinges at an angle of 90 degrees.
5.
Gently slide and lift the palmrest assembly off the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the component and provides a visual representation of the installation procedure.
58
Removing and installing components