Dell Vostro 7500 Service Manual - Page 48

Installing the DC-in port

Get Dell Vostro 7500 PDF manuals and user guides View all Dell Vostro 7500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 48 highlights

5. Lift the DC-in port, along with its cable, off the palm-rest and keyboard assembly. Installing the DC-in port Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the DC-in port and provides a visual representation of the installation procedure. Steps 1. Place the DC-in port on the palm-rest and keyboard assembly. 2. Replace the single screw (M2x3) that secures the DC-in port to the palm-rest and keyboard assembly. 3. Connect the DC-in port cable to the system board. 4. Using the alignment posts, close the left display hinge. 5. Replace the two screws (M2.5x5) and (M2.5x4) that secure the left display hinge to the system board. 48 Disassembly and reassembly

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
5.
Lift the DC-in port, along with its cable, off the palm-rest and keyboard assembly.
Installing the DC-in port
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the DC-in port and provides a visual representation of the installation procedure.
Steps
1.
Place the DC-in port on the palm-rest and keyboard assembly.
2.
Replace the single screw (M2x3) that secures the DC-in port to the palm-rest and keyboard assembly.
3.
Connect the DC-in port cable to the system board.
4.
Using the alignment posts, close the left display hinge.
5.
Replace the two screws (M2.5x5) and (M2.5x4) that secure the left display hinge to the system board.
48
Disassembly and reassembly