Dell XPS 17 9730 Service Manual - Page 21

Fan, Removing the right fan

Get Dell XPS 17 9730 PDF manuals and user guides View all Dell XPS 17 9730 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Steps 1. Align the notch on the solid-state drive with the tab on the solid-state drive slot. 2. Slide the solid-state drive into the solid-state drive slot. 3. Using the alignment post, place the solid-state drive thermal shield over the solid-state drive. 4. Align the screw hole on the solid-state drive thermal shield with the screw hole on the system board. 5. Replace the single screw (M2x4) that secures the solid-state drive thermal shield and the solid-state drive to the system board. NOTE: Repeat step 1 to step 5 to install any additional solid-state drive in your computer. Next steps 1. Install the battery. 2. Install the base cover. 3. Follow the procedure in After working inside your computer. Fan Removing the right fan Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. About this task The following image indicates the location of the right fan and provides a visual representation of the removal procedure. Removing and installing components 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
Steps
1.
Align the notch on the solid-state drive with the tab on the solid-state drive slot.
2.
Slide the solid-state drive into the solid-state drive slot.
3.
Using the alignment post, place the solid-state drive thermal shield over the solid-state drive.
4.
Align the screw hole on the solid-state drive thermal shield with the screw hole on the system board.
5.
Replace the single screw (M2x4) that secures the solid-state drive thermal shield and the solid-state drive to the system
board.
NOTE:
Repeat step 1 to step 5 to install any additional solid-state drive in your computer.
Next steps
1.
Install the
battery
.
2.
Install the
base cover
.
3.
Follow the procedure in
After working inside your computer
.
Fan
Removing the right fan
Prerequisites
1.
Follow the procedure in
Before working inside your computer
.
2.
Remove the
base cover
.
About this task
The following image indicates the location of the right fan and provides a visual representation of the removal procedure.
Removing and installing components
21