Denon AVR-3801 Owners Manual - Page 32

Preset memory By using the preset memory, the included remote control unit can be used to control other makes of video equipment. Note that this is not possible for some models, however. In such cases, use the learning function (see page 34) to store the remote control signals in the remote control unit's memory. See page 37 for instructions on resetting the data stored in the preset memory. 1 Press the power ON/SOURCE button and the OFF button at the same time. • "SET UP" appears on the remote control unit's display. OFF ON / SOURCE 2 Press the ENTER button. ENTER SHIFT 3 Use the D and H cursor buttons to display "ENTER CODE" on the remote control unit, then press the ENTER button. The remote control unit's display switches as follows each time the D and H cursor buttons are pressed. ENTER CODE TUNING CODE NO LEARN BAND MODE TUNING SYS CALL ENTER RESET SHIFT AUTO SEARCH 4 After "SEL MODE" is displayed, the last selected mode is set. Use the D and H cursor buttons to display the component whose codes you want to store in the memory, then press the ENTER button. TUNING ENTER BAND MODE TUNING SHIFT The display switches as shown below each time the D and H cursor buttons are pressed. TV DVD CD VDP MD TAPE CABLE DBS VCR VCR2 1 POWER OFF ON / SOURCE RC-883 REMOTE CONTROL UNIT 3, 4 2, 3, 4 5 TV CD CDR/MD/ TAPE RECEIVER VCR DBS/CABLE VDP DVD DISPLAY SURR. PARA. SETUP TUNING MENU OSD RETURN A/B MEMORY BAND MODE CHANNEL VOLUME TUNING + + SKIP ENTER - SKIP SHIFT MUTING TUNER 1 PHONO 2 CDR/ TAPE VDP 4 5 VCR-1 VCR-2 / V.AUX 7 8 - CD 3 DVD 6 TV/DBS 9 TV/ VCR 0 +10 TEST TONE DOLBY/DTS SURROUND SPEAKER OUTPUT SURROUND DSP SIMU. 5CH / 7CH STEREO 6.1 / 7.1 SURROUND DIRECT MODE INPUT ANALOG SYSTEM CALL CALL 1 CALL 2 STEREO EXT.IN BACKLIGHT 5 Referring to the included List of 1 2 3 Preset Codes, use the number 4 5 6 buttons to input the preset code (a 4-digit number) for the 7 8 9 manufacturer of the component whose signals you want to store in 0 the memory. 6 "OK" is displayed when the signals are registered and the mode is terminated. 7 To store the codes of another component in the memory, repeat steps 1 to 6. NOTES: • The signals for the pressed buttons are emitted while setting the preset memory. To avoid accidental operation, cover the remote control unit's transmitting window while setting the preset memory. • Depending on the model and year of manufacture, this function cannot be used for some models, even if they are of makes listed on the included list of preset codes. • Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and check. The preset codes are as follows upon shipment from the factory and after resetting: TV, VCR HITACHI CD, MD, TAPE, CDR, VDP, DVD, DVD SETUP............DENON DBS GENERAL INSTRUMENT CABLE JERROLD 31