Denon AVR-3803 Owners Manual - Page 36
Preset memory, CD, MD, TAPE, CDR, VDP, DVD - remote codes
View all Denon AVR-3803 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Preset memory The included remote control unit can be used to operate devices of different brands by registering the preset number corresponding to the brand of your device. For some models the remote control unit or the device may not operate properly. In this case, use the learning function (page 39) to store your device's remote control signals in the included remote control unit. For instructions on resetting the preset memory, see page 42. 1 Press the power ON/SOURCE button and the OFF button at the same time. • "PRE" appears on the remote control unit's display. 1 DVD 1 2 Use the • and ª cursor buttons to display "PRE" on the remote control unit, then press the ENTER button. The remote control unit's display switches as follows each time the • and ª cursor buttons are pressed. PRE LRN CALL PUNCH BLKT RST 3 The "SEL" indicator flashes and the device selection mode is set. Use the • and ª cursor buttons to display the mode you want 4 to preset, then press the ENTER button. 4 2, 3 2, 3 1 2 3 4 5 6 7 8 9 0 Referring to the included List of Preset Codes, use the number buttons to input the preset code (a 4-digit number) for the manufacturer of the component whose signals you want to store in the memory. The display switches as shown below each time the • and ª cursor buttons are pressed. CD CDR MD TAPE ZONE2 DVD TV CABLE DBS VCR2 VCR1 VDP It is also possible to select the mode directly using the mode buttons. 5 "OK" is displayed when the signals are registered and the mode is terminated. 6 To store the codes of another component in the memory, repeat steps 1 to 5. NOTES: • Depending on the model and year of manufacture, this function cannot be used for some models, even if the your device is listed on the included list of preset codes. • Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and check it out. • For the CDR/MD, DBS/CABLE, VCR-1/VCR-2 and DVD/VDP modes, the unused mode can be deleted. To delete an unused mode, select the mode to be deleted when registering the preset memory, input preset number "9999", then press the ENTER button. For example, when the MD mode is deleted, only the CDR mode is displayed when the CDR/MD button is pressed. This setting can be canceled by resetting the preset memory or registering another preset signal. The preset codes are as follows upon shipment from the factory and after resetting: TV, VCR1 HITACHI CD, MD, TAPE, CDR, VDP, DVD DENON VCR2, DBS SONY CABLE ABC 36