Denon AVR-990 Owners Manual - English - Page 6
Preparations - manual
UPC - 883795001052
View all Denon AVR-990 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Getting Started Connections Settings Playback ZONE2 Remote Control Information Troubleshooting Specifications ENGLISH Preparations Thank you for purchasing this DENON product. To ensure proper operation, please read this owner's manual carefully before using the product. After reading them, be sure to keep them for future reference. Accessories Check that the following parts are supplied with the product. q Owner's manual 1 w Getting started 1 e Warranty (for North America model only 1 r Service station list 1 t Power cord (Cord length: Approx. 5.9 ft / 1.7 m 1 y Remote control unit (RC-1118 1 u R6/AA batteries (for RC-1118 2 i AM loop antenna (for HD Radio broadcasts 1 o Dipole antenna (for HD Radio broadcasts 1 Q0 Setup microphone (DM-A409, Cord length: Approx. 25 ft / 7.6 m 1 t y i Insert Batteries in the Remote Control Unit In addition to the AVR-990, the included remote control unit (RC-1118) can also be used to operate the equipment listed below. q DENON system components w Non-DENON system components To operate component products other than DENON, you must set the preset code (vpage 84 "Registering Preset Codes"). Inserting the Batteries q Lift the clasp and remove the w Load the two batteries properly rear lid. as indicated by the marks in the battery compartment. R6/AA e Put the rear cover back on. Operating Range of the Remote Control Unit Point the remote control unit at the remote sensor when operating it. Approx. 23 feet / 7 m 30° 30° (RC-1118) NOTE The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light. NOTE • Insert the specified batteries in the remote control unit. • Replace the batteries with new ones if the set does not operate even when the remote control unit is operated close to the unit. (The o Q0 supplied batteries are only for verifying operation.) • When inserting the batteries, be sure to do so in the proper direction, following the "q" and "w" marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not attempt to charge dry batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • Remove the batteries from the remote control unit if it will not be in use for long periods. • Used batteries should be disposed of in accordance with the local regulations regarding battery disposal.