Denon AVR4810CI Owners Manual - English - Page 74

Getting Started Connections Settings Playback Multi-zone Remote Control Information Troubleshooting Specifications n Default settings Auto tuner presets A1 ~ A8 87.5 / 89.1 / 98.1 / 107.9 / 90.1 / 90.1 / 90.1 / 90.1 MHz B1 ~ B8 520 / 600 / 1000 / 1400 / 1500 / 1710 kHz, 90.1 / 90.1 MHz C1 ~ C8 90.1 MHz D1 ~ D8 90.1 MHz E1 ~ E8 90.1 MHz F1 ~ F8 90.1 MHz G1 ~ G8 90.1 MHz Direct Frequency Tuning You can enter the receiving frequency directly to tune in. 1 Press [SEARCH]. 2 Input frequencies by means of [0 ~ 9]. b If o is pressed, the immediately preceding input is cancelled. 3 When setting is completed, press ENTER. The preset frequency is tuned in. Listening to XM Satellite Radio When operating XM with the AVR-4810CI via the main remote control unit or sub remote control unit, use [SAT TU]. Before operating, set to [SAT TU] operating mode. [SAT TU] of [INPUT SOURCE SELECT] and [SAT TU] of [DEVICE SELECT] mode can use only either XM or SIRIUS. The default setting is for SIRIUS operation. 1 Set GUI menu "Option Setup" - "Remote (SIRIUS/ XM)" (vpage 55) to "SAT TU : XM". 2 Press [SOURCE SELECT] to display the GUI Source Select menu, then select " " (vpage 31). The input source becomes that set in step 1. 3 Set the main remote control unit to the "SAT TU" mode (vpage 108 "Operating the Main Remote Control Unit"). You can then operate the input source you set in step 1. 4 Use [TU d] or [TU f] to select the channel. When the channel is tuned in, the name of the song and artist are displayed. 5 Adjust the items below. n Adjusting the master volume (vpage 85) n Selecting the surround mode (vpage 87) n Adjusting the Sound and Picture Quality (vpage 90) Tuning in Radio Stations - FM/AM Broadcasts Checking the XM Signal Strength and Radio ID 1 Press until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display GOOD MARGINAL WEAK NO GUI Status Signal strength is good Signal strength is marginal Signal strength is weak No signal 2 Adjust the position of the antenna until "SIGNAL: GOOD" is shown on the display. 3 Press until the channel (example: "XM001") is displayed. 4 Press [TU d] or [TU f] and select channel 0 (XM000). The radio ID is shown on the display. Radio ID The strength of both the XM satellite and terrestrial signals can be checked "Antenna Aiming" (vpage 64). • The channel switches continuously when [TU d] or [TU f] is pressed and held. • The artist name, song title, category and reception level can be checked by pressing . • The time (default : 30 sec) for which the GUI menus are displayed can be set "GUI" - "Tuner" (vpage 54). Press uio p to return to the original screen. 71