Denon AVR4810CI Owners Manual - English - Page 76
Listening to SIRIUS Satellite Radio
UPC - 883795001151
View all Denon AVR4810CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Getting Started Connections Settings Playback Multi-zone Remote Control Information Troubleshooting Specifications Listening to SIRIUS Satellite Radio When operating SIRIUS with the AVR-4810CI via the main remote control unit or sub remote control unit, use [SAT TU]. Before operating, set to [SAT TU] operating mode. [SAT TU] of [INPUT SOURCE SELECT] and [SAT TU] of [DEVICE SELECT] mode can use only either XM or SIRIUS. The default setting is for SIRIUS operation. 1 Set GUI menu "Option Setup" - "Remote (SIRIUS/ XM)" (vpage 55) to "SAT TU : SIRIUS". 2 Press [SOURCE SELECT] to display the GUI Source Select menu, then select " " (vpage 31). The input source becomes that set in step 1. 3 Set the main remote control unit to the "SAT TU" mode (vpage 108 "Operating the Main Remote Control Unit"). You can then operate the input source you set in step 1. Tuning in Radio Stations - XM Satellite Radio and SIRIUS Satellite Radio Checking the SIRIUS Signal Strength and Radio ID Presetting Radio Channels (Preset Memory) 1 Press until "SIGNAL" appears on the display. The display will switch as shown below, depending on the reception conditions. Display EXCELLENT GOOD WEAK NO SIGNAL Status Signal strength is excellent Signal strength is good Signal strength is weak No signal 2 Adjust the position of the antenna until "SIGNAL: EXCELLENT" is shown on the display. 3 Press until the channel (example: "SR001") is displayed. 4 Press [TU d] or [TU f] and select channel 0 (SR000). Channel No. and Sirius ID are alternately shown on the display. Your favorite broadcast channels can be preset so that you can tune them in easily. Up to 56 channels can be preset. 1 Tune in the broadcast channel you want to preset. 2 Press [MEMO]. 3 Press [A ~ G] to select the block in which the channel is to be preset, then press [CHANNEL] or [1 ~ 8] to select the preset number. b The memory block can also be selected by pressing [SHIFT] on the sub remote control unit. 4 Press [MEMO] again to complete the setting. 4 Use [TU d] or [TU f] to select the channel. When the channel is tuned in, the name of the song and artist are displayed. 5 Adjust the items below. n Adjusting the master volume (vpage 85) n Selecting the surround mode (vpage 87) n Adjusting the Sound and Picture Quality (vpage 90) • The channel switches continuously when [TU d] or [TU f] is pressed and held. • The song title, artist name, composer name, category and reception level can be checked by pressing . • The time (default : 30 sec) for which the GUI menu are displayed can be set "GUI" - "Tuner" (vpage 54). Press uio p to return to the original screen. SR000 SiriusID Sirius ID b Write your own SIRIUS ID for storage use. Sirius ID : The strength of both the SIRIUS satellite and terrestrial signals can be checked "Antenna Aiming" (vpage 64). To preset other channels, repeat steps 1 to 4. NOTE Preset channels are erased by overwriting them. Listening to Preset Channels Press [CHANNEL] to select the desired preset channel, then press ENTER. b Selection is still possible if you press [1 ~ 8] after pressing [A ~ G]. You can also operate via the main unit. In this case, perform the following operations. Press , then turn to select the preset radio channel. 73