Denon DND6000 Operating Instructions - Page 15

9 B TRIM • The Seamless Loop and Sampler B points can be fine-adjusted using the Scratch Disc. • Trim the points during loop playback as a rehearsal. w, r qe 10 AUTO BPM COUNTER / EFFECTOR AUTO BPM COUNTER r ENGLISH B Trim q When the NEXT TR./B TRIM button is pressed during seamless loop playback, the B TRIM mode is turned on. When the NEXT TR./B TRIM is pressed during playback,the NEXT TRACK mode is set. If the button 1 is pressed again without performing the NEXT TRACK mode operation, the B TRIM mode is selected. Select B point w The A button illumination automatically flashes for the last loop created or 2 accessed. • Or the A button or the SAMP button is selected pressing. Trim B point e Turn Scratch Disc slowly to move the B point 1 frame at a time. • Range for trimming B point is limited as follows. B point for Loop: 3 Between 5 frames after A point and disc end. B point for Sampler: Between 5 frames after A point and Sampler end. *MP3 Between 5 frames after A point and file end. Save the B point r Push the A or SAMP button again to save new B point, 4 and the unit automatically exit from the B Trim mode. q, w, e, t AUTO BPM COUNTER Beats per minute (BPM) of a track is measured automatically and displayed during playback or in Cue standby mode. Measured BPM values are synchronized with the effector parameters such as:(ECHO/LOOP and FLANGER time) • When Auto BPM COUNTER is off, pushing the TAP button for 1 second, reactivates the AUTO BPM COUNTER to turn back on. • If you change or select a new track, the old BPM is cleared and the Auto BPM Counter starts to detect the new track automatically. NOTE: AUTO BPM COUNTER might not be able to be measured correctly according to the music. *If this happens, please use the TAP feature. BPM LOCK The data measured by the auto BPM counter is locked. 1 q Push the TAP button once while auto BPM counter is operating. "BPM Lock" is displayed for 1 second. TAPPING The interval when the TAP button is pushed repeatedly is measured and BPM is 2 calculated. w When you push the TAP button, the auto BPM counter turn off. Push the TAP button repeatedly about 5~10 times according to the beat. MANUAL INPUT The known BPM can be dialed in directly by the numerical value. e The BPM manual input mode is available when the TAP button is pushed for more than 2 sec. "Manual 3 In" is displayed is the screen. r You can input BPM value directly with the PARAMETERS knob. t When the TAP button is pushed again, the BPM manual input mode is turned off and the BPM is locked to that value. 15