Denon DNHD2500 Operating Instructions - Page 16

ENGLISH 5 BASIC OPERATION Play and pause • Each push of the PLAY/PAUSE button switches between playback and pause. PLAY/PAUSE button illuminates solid green during playback and flashes in pause. • When the PLAY/PAUSE button is pushed during play, the DN-HD2500 pauses playback at that point. Push PLAY/PAUSE button once again and playback resumes. • Playback will pause when SCRATCH is selected with the JOG MODE button and the JOG disc is held with your hand. Playback resumes when your hand is released. Play and Cue • When the CUE button is pushed during playback, the file stops and returns to the original position of which playback started from, the (Cue point). This function is also called Back-Cue. With the Back-Cue function, you can start from exactly same position. The CUE button illuminates solid red when DN-HD2500 is ready to start playback. • You can set and change Cue point as follows. • When you started playback. • File select finished. • Manual search. Select the file • Turn the PARAMETERS knob or JOG disc. !Move the Cue point • If you would like to start playback other from the beginning of the file, you need to move Cue Point using fast Search, scan and manual search function. You can move to the approximate playback start position by FAST SEARCH buttons. [QUICK JUMP] 1 • If the FAST SEARCH button is tapped shortly, the playback position jumps about 10 seconds. The jump time can be selected in the preset mode from 10, 20, 30 or 60 sec. [FAST SEARCH] • When the FAST SEARCH button is pressed and held in, the file/Track is fast-searched. Push the JOG MODE button to set JOG disc to search mode. The JOG MODE button will turn off. 2 Turn the JOG disc to change Cue point. You can hear the short 3 sound of the current Cue point. When JOG disc is turned in the pause, Cue or frame repeat mode, it works as the manual search function. After you found your preferred Cue point, push the CUE button 4 then a new Cue point is set. Adjusting the pitch • With Pitch slider you can adjust the playback speed (Pitch). • If you would not prefer to change key of sound, use the Key Adjust function. Push the PITCH/KEY button to PITCH indicator lights up. • PITCH → KEY (key adjust) → 1 OFF NOTE: The display will indicate "KEY", when key adjust is ON. Pitch decreases Move the Pitch Slider to adjust the 2 pitch. The current pitch setting is displayed on the display. Pitch increases Pitch Bend • With PITCH BEND function you can change pitch temporary. DN-HD2500 has two ways for this function PITCH BEND buttons and JOG disc. [PITCH BEND +/- buttons] • Push the PITCH BEND button for momentary change of pitch. 1 While holding these buttons down, the pitch continues to change up to the limitation. • After releasing the PITCH BEND buttons, playback pitch returns to slider setting. [JOG disc] • When the JOG mode is set to 2 SEARCH/BEND with the JOG MODE button, the playback speed can be changed by turning JOG disc during playback. DN-HD2500 has six pitch ranges, 4 %, 10 %, 16 %, 24 %, 50 % and 100%. When the RANGE button is pushed for more than 1 sec, the pitch range can be 3 selected with the PARAMETERS knob. • When the PARAMETERS knob is pushed the pitch range is entered and the pitch range selection mode is cancelled. Power on play • When "POWER ON PLAY" is set to "ON" at ⁄5 PRESET "(10) Power On Play", playback starts from the first file on the "Favorites" when the power is turned on. 11 ENGLISH