Denon S52WT Owners Manual - Page 35

Troubleshooting

Page 35 highlights

Getting Started Connections Setup Playback Information Troubleshooting Troubleshooting If a problem should arise, first check the following: 1. Are the connections correct? 2. Is the set being operated as described in the owner's manual? 3. Are the other components operating properly? If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction. In this case, disconnect the power immediately and contact your store of purchase. GGeneralH Symptom Display not lit and sound not produced when power switch set to on. Display lit but sound not produced. Display is dim. Cause Countermeasure • Power cord not plugged in • Plug the power cord into the wall securely. power outlet. • Device you want to play and set • Select an appropriate input input source do not match. source. • Volume control set to minimum. • Turn volume up to suitable level. • MUTING is on. • Switch off MUTING. • Dimmer function is on. • Turn the dimmer function off by pressing the DIMMER button. Page 10 15 15 15 15 GRemote Control UnitH Symptom Cause Countermeasure Set does not work • Batteries are worn. • Replace with new batteries. properly when • You are operating outside of the • Operate within the specified remote control specified range. range. unit operated. • Obstacle between main unit and • Remove the obstacle. remote control unit. • The batteries are not inserted in • Insert the batteries in the the proper direction, as indicated proper direction, following the by the polarity marks in the polarity marks in the battery battery compartment. compartment. • The set's remote control sensor • Move the set to a place in which is exposed to strong light (direct the remote control sensor will sunlight, inverter type fluorescent not be exposed to strong light. bulb light, etc.). Page 4 4 4 4 4 GCDH Symptom Cause Countermeasure "No Disc" is shown on the display even though a CD is loaded. • The disc is not properly loaded. • Reload the disc. Disc is not played • The disc is dirty or scratched. when 1/3 button • Wipe the dirt off the disc or replace the disc. is pressed. A specific part of • The disc is dirty or scratched. a disc is not played. • Wipe the dirt off the disc or replace the disc. A CD-R or CD-RW • The disc has not been finalized. • Finalize the disc then play it. disc cannot be • The recording conditions are bad • Use a properly recorded disc. played. or the quality of the disc itself it poor. MP3 and WMA • The file formats, extensions or • Create discs with file formats, files cannot be settings made when disc was extensions or settings compatible played. created are not compatible with with the S-52. the S-52. GiPodH Symptom iPod cannot be played. Cause Countermeasure • Input source is not right. • Select an appropriate source. • iPod is not properly mounted in • Remount the iPod. dock for ipod. input ENGLISH Page 3 3 3 3 - 24 Page 20 7 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39

³±
Getting Started
Connections
Setup
Playback
Information
ENGLISH
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Troubleshooting
Symptom
Cause
Countermeasure
Page
Display not lit
and sound not
produced when
power switch set
to on.
• Power
cord
not
plugged
in
securely.
• Plug the power cord into the wall
power outlet.
10
Display lit but
sound not
produced.
• Device you want to play and set
input source do not match.
• Volume control set to minimum.
• MUTING is on.
• Select
an
appropriate
input
source.
• Turn volume up to suitable level.
• Switch off MUTING.
15
15
15
Display is dim.
• Dimmer function is on.
• Turn the dimmer function off by
pressing the
DIMMER
button.
15
G
General
H
G
Remote Control Unit
H
Symptom
Cause
Countermeasure
Page
Set does not work
properly when
remote control
unit operated.
• Batteries are worn.
• You are operating outside of the
specified range.
• Obstacle between main unit and
remote control unit.
• The batteries are not inserted in
the proper direction, as indicated
by the polarity marks in the
battery compartment.
• The set’s remote control sensor
is exposed to strong light (direct
sunlight, inverter type fluorescent
bulb light, etc.).
• Replace with new batteries.
• Operate within the specified
range.
• Remove the obstacle.
• Insert
the
batteries
in
the
proper direction, following the
polarity marks in the battery
compartment.
• Move the set to a place in which
the remote control sensor will
not be exposed to strong light.
4
4
4
4
4
Symptom
Cause
Countermeasure
Page
“No Disc” is
shown on the
display even
though a CD is
loaded.
• The disc is not properly loaded.
• Reload the disc.
3
Disc is not played
when
1
/
3
button
is pressed.
• The disc is dirty or scratched.
• Wipe the dirt off the disc or
replace the disc.
3
A specific part of
a disc
is not played.
• The disc is dirty or scratched.
• Wipe the dirt off the disc or
replace the disc.
3
A CD-R or CD-RW
disc cannot be
played.
• The disc has not been finalized.
• The recording conditions are bad
or the quality of the disc itself it
poor.
• Finalize the disc then play it.
• Use a properly recorded disc.
3
MP3 and WMA
files cannot be
played.
• The file formats, extensions or
settings made when disc was
created are not compatible with
the S-52.
• Create discs with file formats,
extensions or settings compatible
with the S-52.
24
G
CD
H
Symptom
Cause
Countermeasure
Page
iPod cannot be
played.
• Input source is not right.
• iPod is not properly mounted in
dock for ipod.
• Select
an
appropriate
input
source.
• Remount the iPod.
20
7
G
iPod
H
Troubleshooting